Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › 2013.12–2014.12
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278059 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 71940A 1.REMOVE REAR SEAT HEADREST ASSEMBLY

Hide 71960B 2.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

Hide 67918A 8.REMOVE REAR DOOR SCUFF PLATE LH

Hide 62332A 9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 64995 12.REMOVE DECK FLOOR BOX RH

HINT:

Use the same procedure as for the LH side.


Hide 64330D 13.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 73370 15.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

Hide 81330 17.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Hide 64740C 18.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 86011R 19.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E282156

Remove the bolt.


b.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E221953

Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.


d.
E227453

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.