71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
71960B
2.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
58165F
3.REMOVE FRONT FLOOR COVER RH
58166B
4.REMOVE FRONT FLOOR COVER LH
58167H
5.REMOVE FRONT CENTER FLOOR COVER
6.REMOVE REAR SEATBACK ASSEMBLY (for Bench Type Seatback)
7.REMOVE REAR SEATBACK ASSEMBLY LH (for Separate Type Seatback)
8.REMOVE REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback)
9.REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
67918A
10.REMOVE REAR DOOR SCUFF PLATE LH
62332A
11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
58410B
12.REMOVE DECK BOARD ASSEMBLY
64997
13.REMOVE DECK FLOOR BOX LH
64995
14.REMOVE DECK FLOOR BOX RH
Use the same procedure as for the LH side.
64330D
15.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64716D
16.REMOVE REAR DECK TRIM COVER
73370
17.DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
58732C
18.REMOVE REAR ABSORBER CAP LH
81330
19.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
64740C
20.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
86011R
21.REMOVE RADIO SETTING CONDENSER
When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.
Remove the bolt.
Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.
Using a screwdriver, bend back and break off the claw as shown in the illustration.
Remove the terminal cover from the wire harness.
Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.
Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
Check for deformation of the terminal after the wire harness has been removed from the terminal cover.