Home › Power Source / Network › 1NZ-FXE BATTERY / CHARGING › AUXILIARY BATTERY › 2015.11–2017.06
RM2170E _57 Power Source / Network _057031 1NZ-FXE BATTERY / CHARGING _0278063 AUXILIARY BATTERY A

1NZ-FXE BATTERY / CHARGING  AUXILIARY BATTERY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AUXILIARY BATTERY

a.

Install the battery insulator.


b.

Install the battery.


c.

Connect the battery ventilation hose to the battery without kinking it.

HINT:

Push in the battery ventilation hose to the battery until a click sound is heard.



d.

Connect the positive (+) battery terminal with the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Install the battery terminal cap.


f.

Install the battery clamp with the 2 nuts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

a.

Connect the negative battery terminal with the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).