The main body ECU (multiplex network body ECU) receives signals from the back door opener switch assembly. Then, the main body ECU (multiplex network body ECU) activates the back door lock motor.
The power door lock control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power door lock control system after confirming that the communication systems are functioning properly.
Check the power door lock basic function (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK).
The power door lock basic functions operate normally.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Back Door Open | Back door lock/Permit or Prohibt | Permit: Back door unlocked
Prohibt: Back door locked |
- |
The intelligent tester indicates Permit or Prohibit according to the door lock operation shown in the table.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Trunk and Back-Door Open | Operate back door lock motor | ON or OFF | - |
The back door lock assembly unlatches when ON is selected.
OK
NG
Remove the back door lock assembly (See page Vehicle Interior>DOOR LOCK>BACK DOOR LOCK>REMOVAL).
Check the operation of the door lock motor.
Move the door lock to the lock position.
Apply auxiliary battery voltage to the door lock motor and check the operation of the door lock motor.
| Connection | Result |
|---|---|
| Auxiliary battery positive (+) → Terminal 1 (ACT+)
Auxiliary battery negative (-) → Terminal 2 (ACT-) |
Unlocks |
Check the operation of the door courtesy switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (ACT-) - 3 (D+) | Locked | 10 kΩ or higher |
| 2 (ACT-) - 3 (D+) | Unlocked | Below 1 Ω |
| *a | Component without harness connected
(Back Door Lock Assembly) |
| *b | Lock |
| *c | Unlock |
OK
NG
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T5-1 (ACT+) - 3D-9 (TR+) | Always | Below 1 Ω |
| T5-1 (ACT+) - Body ground | Always | 10 kΩ or higher |
| T5-3 (D+) - 3D-35 (BCTY) | Always | Below 1 Ω |
| T5-3 (D+) - Body ground | Always | 10 kΩ or higher |
| T5-2 (ACT-) - Body ground | Always | Below 1 Ω |
OK
NG
Replace the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
NEXT
Check that the back door can be opened.
The back door can be opened normally.
OK
NG