Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK › from 2015.11
RM2170E _58 Vehicle Interior _057034 DOOR LOCK _0278075 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY

NOTICE:
·

When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.



a.

Apply MP grease to the sliding parts of the rear door lock assembly.


b.

When reusing the rear door lock assembly:

i.

Install a new door lock wiring harness seal to the rear door lock assembly.



c.
B307170E01
0.354,0.98 0.354,1.352 false 0.271,1.376 0.611,1.518 0.340,0.142 10 *1

Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.

Text in Illustration
*1 Release Plate


d.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.


e.

Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Install the rear door lock child protection cover.


Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

a.
B307171

Install the rear door quarter window glass in the direction indicated by the arrow in the illustration.


Hide 67408E 6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67604 10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 67674A 12.INSTALL REAR DOOR FRAME GARNISH

Hide 13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 15.CHECK POWER WINDOW CONTROL SYSTEM