Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › from 2014.12
RM2170E _58 Vehicle Interior _057035 THEFT DETERRENT / KEYLESS ENTRY _0278082 ENGINE IMMOBILISER SYSTEM T

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

If the problem only occurs in certain locations or at certain times of day, check for wave interference.

·

If the vehicle components are added, check for wave interference from the added components.



Engine Immobiliser System
Symptom Suspected Area See page
Security indicator light does not blink Proceed to "Security Indicator Light Does not Blink" (Click here)
Hybrid control system cannot be started*1 Certification ECU (Smart key ECU assembly) (Click here)
Hybrid control system cannot be started*1 ID code box (Immobiliser code ECU) (Click here)
Hybrid vehicle control ECU (Click here)
Hybrid control system (Click here)
Power source mode cannot be changed*1 Power switch (Click here)
Certification ECU (Smart key ECU assembly) (Click here)
Steering lock lock/unlock not possible*2 Steering lock ECU (Steering lock actuator assembly) (Click here)

*1: Refer to Problem Symptoms Table for Smart Entry and Start System (for Start Function).

*2: Refer to Problem Symptoms Table for Steering Lock System.