Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM2170E _58 Vehicle Interior _057036 LIGHTING (INT) _0278087 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Rear Door Courtesy Switch Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the rear door courtesy light switch using this circuit.

WIRING DIAGRAM

E227472E15
5.573,0.427 5.885,0.573 0.313,0.146 10 false 24 5.635,1.365 5.729,1.542 0.094,0.177 10 false 6 5.927,0.625 6.385,0.802 0.458,0.177 10 false LCTY 5.938,1.552 6.396,1.729 0.458,0.177 10 false RCTY 1.01,0.802 1.354,0.979 0.344,0.177 10 false M3 1.01,0.979 3.906,1.156 2.896,0.177 10 false Rear Door Courtesy Light Switch Assembly LH 1,1.75 1.344,1.927 0.344,0.177 10 false M4 1,1.917 3.917,2.094 2.917,0.177 10 false Rear Door Courtesy Light Switch Assembly RH 3.063,0.51 3.156,0.688 0.094,0.177 10 false 1 3.063,1.469 3.156,1.646 0.094,0.177 10 false 1 5.542,1.938 6.823,2.563 1.281,0.625 10 false Main Body ECU (Multiplex Network Body ECU) 5.531,0.625 5.938,0.802 0.406,0.177 10 false G59 5.531,1.563 5.938,1.74 0.406,0.177 10 false G59

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

Read the display on the intelligent tester.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door Courtesy Rear door courtesy light switch RH signal/OPEN or CLOSE OPEN: Rear door RH open
CLOSE: Rear door RH closed
-
RL Door Courtesy Rear door courtesy light switch LH signal/OPEN or CLOSE OPEN: Rear door LH open
CLOSE: Rear door LH closed
-

OK:

Normal conditions listed above are displayed.


Result:
Result Proceed to
OK A
Rear door courtesy light switch LH or RH does not operate B




A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH)
2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH)
a.

Remove the rear door courtesy light switch assembly (See page Vehicle Interior>LIGHTING (INT)>REAR DOOR COURTESY SWITCH>REMOVAL).


b.

Inspect the rear door courtesy light switch assembly (See page Vehicle Interior>LIGHTING (INT)>REAR DOOR COURTESY SWITCH>INSPECTION).

OK:

Rear door courtesy light switch assembly is normal.


Result:
Result Proceed to
OK (for Rear LH) A
OK (for Rear RH) B
NG C




A

3.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

B

4.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))

C

REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
a.

Disconnect the G59 main body ECU (multiplex network body ECU) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M3-1 - G59-24 (LCTY) Always Below 1 Ω
M3-1 - Body ground Always 10 kΩ or higher




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
a.

Disconnect the G59 main body ECU (multiplex network body ECU) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M4-1 - G59-6 (RCTY) Always Below 1 Ω
M4-1 - Body ground Always 10 kΩ or higher




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR