Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278101 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


PROCEDURE

Hide 45100 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 2.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

Hide 84307 4.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the spiral cable from the steering sensor.



a.
B289075E02
0.813,0.865 0.927,0.979 0.927,0.979 1.115,0.979 true 1.146,0.896 1.365,1.063 0.219,0.167 10 false *a

Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

Text in Illustration
*a Slider

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect the other connector from the spiral cable with sensor sub-assembly.


c.
B312019

Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.