73900
1.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
for LHD:
Temporarily install the lower No. 1 instrument panel airbag assembly with the 7 claws and the 3 guides.
Install the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
for RHD:
Temporarily install the lower No. 1 instrument panel airbag assembly with the 9 claws and the 2 guides.
Install the 4 bolts.
Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
45287
2.INSTALL LOWER STEERING COLUMN COVER
3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
84307
4.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
45100
5.INSTALL STEERING WHEEL ASSEMBLY