45100
1.REMOVE STEERING WHEEL ASSEMBLY
45287
2.REMOVE LOWER STEERING COLUMN COVER
73900
3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
for LHD:
Remove the 4 bolts.
Disengage the 7 claws and the 3 guides to remove the lower No. 1 instrument panel airbag assembly.
When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.
for RHD:
Remove the 4 bolts.
Disengage the 9 claws and the 2 guides to remove the lower No. 1 instrument panel airbag assembly.
When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.