Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2011.12–2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278103 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 82142A 1.INSTALL NO. 2 INSTRUMENT PANEL WIRE

a.
B300251E01
0.313,1.023 0.474,1.198 0.161,0.175 10 *1 1.644,2.768 1.806,2.943 0.161,0.175 10 *2 2.289,2.695 2.11,2.874 2.11,2.874 1.829,2.874 false 0.517,1.106 1.515,1.106 false

Connect the airbag connector of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

Text in Illustration
*1 Airbag Connector
*2 Airbag Connector Lock

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



b.

Push in the airbag connector lock to install the airbag connector to the instrument panel passenger airbag assembly.


c.

Connect the No. 2 instrument panel wire to the instrument panel passenger airbag assembly clamp.


Hide 73960A 2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Engage the 3 hooks.


b.

Push the instrument panel passenger airbag assembly to engage the 3 hooks.


c.

Install the 2 screws to install the instrument panel passenger airbag assembly.


d.

Engage the clamp to the upper instrument panel assembly.


Hide 3.INSTALL NO. 2 HEATER TO REGISTER DUCT ASSEMBLY

Hide 82142A 5.CONNECT NO. 2 INSTRUMENT PANEL WIRE

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B300246

Connect the connector.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



Hide 62211 6.INSTALL FRONT PILLAR GARNISH RH