55359D
1.INSTALL NO. 5 INSTRUMENT PANEL CUSHION
Align the marking lines on the upper instrument panel with the ends of a new No. 5 instrument panel cushion and install the No. 5 instrument panel cushion as shown in the illustration.
| *1 | Marking Line |
55349A
2.INSTALL INSTRUMENT PANEL CUSHION
Align the marking lines on the upper instrument panel with the ends of a new instrument panel cushion and install the instrument panel cushion as shown in the illustration.
Align the marking lines on the upper instrument panel with the ends of the instrument panel cushion and install a new instrument panel cushion as shown in the illustration.
| *1 | Marking Line | - | - |
55356C
3.INSTALL NO. 2 INSTRUMENT PANEL CUSHION
Using hot-melt glue, install a new No. 2 instrument panel cushion.
55355
4.INSTALL NO. 1 INSTRUMENT PANEL CUSHION
Using hot-melt glue, install 4 new No. 1 instrument panel cushions.
55381A
5.INSTALL FINISH PANEL MOUNTING BRACKET
Install the finish panel mounting bracket with the 2 screws <B>.
Use the same procedure for the RH and LH sides.
73960A
6.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
55972C
7.INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
Install the No. 2 side defroster nozzle duct to the No. 2 heater to register duct with the 3 screws <B>.
55971C
8.INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT
Install the No. 1 side defroster nozzle duct to the No. 1 heater to register duct with the 3 screws <B>.
9.INSTALL NO. 2 HEATER TO REGISTER DUCT ASSEMBLY
Install the No. 2 heater to register duct assembly with the 3 screws <B>.
10.INSTALL NO. 1 HEATER TO REGISTER DUCT ASSEMBLY
Install the No. 1 heater to register duct assembly with the 3 screws <B>.
55962
11.INSTALL NO. 2 SIDE DEFROSTER NOZZLE
Engage the 4 claws to install the No. 2 side defroster nozzle.
55961
12.INSTALL NO. 1 SIDE DEFROSTER NOZZLE
Engage the 4 claws to install the No. 1 side defroster nozzle.
55650
13.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)
Engage the 3 clips to install the No. 1 instrument panel register assembly.
55660
14.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD)
Engage the 3 clips to install the No. 2 instrument panel register assembly.