1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
62211
2.REMOVE FRONT PILLAR GARNISH RH
82142A
3.DISCONNECT NO. 2 INSTRUMENT PANEL WIRE
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Slide the slider to release the lock, and then disconnect the connector.
| *a | Slider |
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
4.REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
5.REMOVE NO. 2 HEATER TO REGISTER DUCT ASSEMBLY
73960A
6.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.
Remove the 2 screws.
Disengage the clamp from the upper instrument panel assembly.
Lean the upper instrument panel assembly and disengage the 3 hooks.
Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly.
82142A
7.REMOVE NO. 2 INSTRUMENT PANEL WIRE
Separate the No. 2 instrument panel wire from the instrument panel passenger airbag assembly clamp.
| *1 | Protective Tape |
| *2 | Airbag Connector |
| *3 | Airbag Connector Lock |
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
Disconnect the airbag connector to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.