Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057041 SEAT BELT _0278118 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


Hide 58166B 5.REMOVE FRONT FLOOR COVER LH (for LH Side)

Hide 62312B 7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 62332A 8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 73233C 9.REMOVE LAP BELT OUTER ANCHOR COVER

a.
B307770

Disengage the 3 claws and remove the lap belt outer anchor cover.


Hide 73220 10.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B307771

Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.


Hide 62414A 11.REMOVE CENTER PILLAR LOWER GARNISH

Hide 62412B 12.REMOVE CENTER PILLAR UPPER GARNISH

Hide 73220 13.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B307772

Remove the bolt and the disconnect the shoulder anchor of the front seat outer belt assembly.


b.
B307778E01
1.344,3.035 1.521,3.238 0.177,0.203 10 *1 0.999,3.196 1.329,3.125 false

Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

Text in Illustration
*1 Protective Tape


c.

Disconnect the pretensioner connector.


d.
B307779

Remove the 2 bolts.


e.

Disengage the 2 hooks and remove the front seat outer belt assembly.