1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58165F
2.REMOVE FRONT FLOOR COVER RH
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
67914
4.REMOVE FRONT DOOR SCUFF PLATE
58166B
5.REMOVE FRONT FLOOR COVER LH (for LH Side)
67918A
6.REMOVE REAR DOOR SCUFF PLATE
62312B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
62332A
8.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
73233C
9.REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws and remove the lap belt outer anchor cover.
73220
10.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.
62414A
11.REMOVE CENTER PILLAR LOWER GARNISH
62412B
12.REMOVE CENTER PILLAR UPPER GARNISH
73220
13.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and the disconnect the shoulder anchor of the front seat outer belt assembly.
Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
| *1 | Protective Tape |
Disconnect the pretensioner connector.
Remove the 2 bolts.
Disengage the 2 hooks and remove the front seat outer belt assembly.