Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2014.12–2017.06
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278125 AIR CONDITIONING SYSTEM U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  TERMINALS OF ECU  


AIR CONDITIONING AMPLIFIER ASSEMBLY


U183683E02
5.167,0.188 5.344,0.375 0.177,0.188 10 false z1 2.979,0.188 3.292,0.344 0.313,0.156 10 false G34

HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
G34-1 (IG+) - G34-14 (GND) V - W-B Power source (IG) Power switch on (IG) 11 to 14 V
G34-1 (IG+) - G34-14 (GND) V - W-B Power source (IG) Power switch off Below 1 V
G34-4 (ECOS) - G34-14 (GND) R - W-B ECO mode switch (eco switch assembly) signal Power switch on (IG)
ECO mode switch (eco switch assembly): on
Below 1 V
G34-4 (ECOS) - G34-14 (GND) R - W-B ECO mode switch (eco switch assembly) signal Power switch on (IG)
ECO mode switch (eco switch assembly): off
11 to 14 V
G34-5 (TAM) - G34-13 (SG-2) W - B Ambient temperature sensor signal Power switch on (IG)
Ambient temperature: 25°C (77°F)
1.8 to 2.2 V
G34-5 (TAM) - G34-13 (SG-2) W - B Ambient temperature sensor signal Power switch on (IG)
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
G34-9 (PRE) - G34-13 (SG-2) GR - B Air conditioning pressure sensor signal Power switch on (READY)
A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.9 kgf/cm2, 439 psi))
4.62 V or higher
G34-9 (PRE) - G34-13 (SG-2) GR - B Air conditioning pressure sensor signal Power switch on (READY)
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 25 psi))
Below 0.74 V
G34-9 (PRE) - G34-13 (SG-2) GR - B Air conditioning pressure sensor signal Power switch on (READY)
A/C system operating
Refrigerant pressure: Normal pressure (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi))
0.74 to 4.62 V
G34-10 (S5-3) - G34-13 (SG-2) Y - B Power supply for air conditioning pressure sensor Power switch on (IG) 4.75 to 5.25 V
G34-10 (S5-3) - G34-13 (SG-2) Y - B Power supply for air conditioning pressure sensor Power switch off Below 1 V
G34-11 (CANH) - G34-12 (CANL) V - W CAN communication system CAN communication occurring Pulse generation
G34-13 (SG-2) - Body ground B - Body ground Ground for air conditioning pressure sensor, ambient temperature sensor Always Below 1 V
G34-14 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 V
G34-21 (B) - G34-14 (GND) BE - W-B Power source (Back-up) Power switch off 11 to 14 V
G34-22 (BLW) - G34-14 (GND) R - W-B Blower motor speed control signal Power switch on (IG)
Blower switch: LO
Pulse generation
(See waveform 1)
G34-29 (TR) - G34-34 (SG-1) P - SB Room temperature sensor signal Power switch on (IG)
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
G34-29 (TR) - G34-34 (SG-1) P - SB Room temperature sensor signal Power switch on (IG)
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
G34-30 (S5-4) - G34-14 (GND) R - W-B Power supply for solar sensor Power switch on (IG) 4.75 to 5.25 V
G34-30 (S5-4) - G34-14 (GND) R - W-B Power supply for solar sensor Power switch off Below 1 V
G34-33 (TS) - G34-14 (GND) V - W-B Solar sensor signal Power switch on (IG)
Solar sensor subjected to electric light
0.8 to 4.3 V
G34-33 (TS) - G34-14 (GND) V - W-B Solar sensor signal Power switch on (IG)
Solar sensor covered with a cloth
Below 0.8 V
G34-34 (SG-1) - Body ground SB - Body ground Ground for room temperature sensor Always Below 1 V
G34-37 (LIN1) - G34-14 (GND) LG - W-B LIN communication signal Power switch on (IG) Pulse generation
z1-2 (BUS G) - Body ground - Ground for BUS IC Always Below 1 V
z1-3 (BUS) - z1-2 (BUS G) - BUS IC control signal Power switch on (IG) Pulse generation
z1-4 (B BUS) - z1-2 (BUS G) - Power supply for BUS IC Power switch off 11 to 14 V
z1-5 (SGA) - Body ground - Ground for evaporator temperature sensor Always Below 1 V
z1-6 (TEA) - z1-5 (SGA) - Evaporator temperature sensor signal Power switch on (IG)
Evaporator temperature: 0°C (32°F)
2.0 to 2.4 V
z1-6 (TEA) - z1-5 (SGA) - Evaporator temperature sensor signal Power switch on (IG)
Evaporator temperature: 15°C (59°F)
1.4 to 1.8 V

a.
E103396E01
2.918,1.568 3.317,1.779 0.399,0.211 10 GND

Waveform 1:

Item Content
Terminal No. G34-22 (BLW) - G34-14 (GND)
Tool Setting 1 V/DIV., 500 μs/DIV.
Vehicle Condition Power switch on (IG)
Blower switch: LO



AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)


U159683E02
3.417,0.313 4.073,0.698 0.656,0.385 10 false G33

HINT:

Check from the rear of the connector while it is connected to the air conditioning panel (heater control switch board).


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
G33-2 (LIN1) - Body ground LG - Body ground LIN communication signal Power switch on (IG) Pulse generation
G33-3 (SWO) - G33-8 (GND) G - W-B Steering pad switch assembly signal Power switch off Below 1 V
G33-3 (SWO) - G33-8 (GND) G - W-B Steering pad switch assembly signal Power switch on (IG) 4.5 to 5.5 V
G33-5 (IG+) - G33-8 (GND) V - W-B Power source (IG) Power switch off Below 1 V
G33-5 (IG+) - G33-8 (GND) V - W-B Power source (IG) Power switch on (IG) 11 to 14 V
G33-6 (ILL+) - Body ground R - Body ground Illumination signal Light control switch off Below 1 V
G33-6 (ILL+) - Body ground R - Body ground Illumination signal Light control switch tail or head position 11 to 14 V
G33-7 (ILL-) - Body ground W - Body ground Illumination signal Light control switch off Below 1 V
G33-8 (GND) - Body ground W-B - Body ground Ground for air conditioning panel (heater control switch board) Always Below 1 V