Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278125 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  IG Power Source Circuit  


DESCRIPTION

Power is supplied to the air conditioning amplifier assembly when the power switch is turned on (IG).

The power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E229257E75
5.948,2.203 6.404,2.377 0.456,0.174 10 GND 5.724,0.837 5.825,1.012 0.101,0.174 10 1 5.653,2.109 5.824,2.284 0.172,0.174 10 14 5.47,3.544 5.788,3.718 0.319,0.174 10 G34 5.47,3.715 7.064,4.046 1.594,0.332 10 Air Conditioning Amplifier Assembly 0.031,1.566 1.618,1.880 1.587,0.314 10 from Power Management Control ECU 5.948,0.931 6.390,1.106 0.443,0.174 10 IG+ 4.528,1.166 5.029,1.340 0.501,0.174 10 HTR-IG 3.021,1.88 3.779,2.055 0.759,0.174 10 IG1 NO. 1 0.24,0.922 1.581,1.097 1.340,0.174 10 from Auxiliary Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the G34 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G34-1 (IG+) - Body ground Power switch off Below 1 V
G34-1 (IG+) - Body ground Power switch on (IG) 11 to 14 V




OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G34-14 (GND) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR