Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › from 2014.12
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278125 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  IG Power Source Circuit  


DESCRIPTION

Power is supplied to the air conditioning amplifier assembly when the power switch is turned on (IG).

The power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E229257E76
5.927,2.24 6.5,2.594 0.573,0.354 10 false GND 5.729,0.833 6.052,1.146 0.323,0.313 10 false 1 5.667,2.125 6.302,2.521 0.635,0.396 10 false 14 5.469,3.469 5.99,3.875 0.521,0.406 10 false G34 5.469,3.646 7.094,4.188 1.625,0.542 10 false Air Conditioning Amplifier Assembly 5.938,0.958 6.469,1.385 0.531,0.427 10 false IG+ 4.563,1.198 5.344,1.656 0.781,0.458 10 false HTR-IG 3.042,1.917 3.854,2.417 0.813,0.5 10 false IG1 NO. 1 0.792,0.938 1.802,1.26 1.01,0.323 10 false from Battery 0.229,1.604 1.615,2.125 1.385,0.521 10 false from Certification ECU(Smart Key ECU Assembly)

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the G34 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G34-1 (IG+) - Body ground Power switch off Below 1 V
G34-1 (IG+) - Body ground Power switch on (IG) 11 to 14 V




OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G34-14 (GND) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR