The air conditioning panel (heater control switch board) communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning panel (heater control switch board) is operated.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B14B2 | Lost communication with the air conditioning panel (heater control switch board). | ·
Harness or connector between air conditioning panel (heater control switch board) and IG power source ·
Harness or connector between air conditioning panel (heater control switch board) and body ground ·
LIN communication system ·
Air conditioning panel (heater control switch board) ·
Air conditioning amplifier assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G33 air conditioning panel (heater control switch board) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-5 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| G33-5 (IG+) - Body ground | Power switch off | Below 1 V |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-8 (GND) - Body ground | Always | Below 1 Ω |
OK
NG
Disconnect the G34 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G33-2 (LIN1) - G34-37 (LIN1) | Always | Below 1 Ω |
| G33-2 (LIN1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the air conditioning panel (heater control switch board) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL>DISASSEMBLY).
Since the air conditioning panel (heater control switch board) cannot be inspected while it is removed from the vehicle, replace the air conditioning panel (heater control switch board) with a new or known good one and check that the condition returns to normal.
Air conditioning panel (heater control switch board) operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to Problem Symptoms Table) | B |
| NG (When troubleshooting according to the DTC) | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C