Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278127 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PIPING CLAMP

a.

Remove the vinyl tape from the open ends of the suction pipe sub-assembly and suction hose sub-assembly.


b.
E248686E03
0.99,0.188 1.188,0.667 false 1.885,0.177 1.438,0.635 true 0.792,1.458 0.792,1.76 false 0.74,1.802 0.979,2 0.24,0.198 10 false *1 0.813,0.031 1.052,0.229 0.24,0.198 10 false *2 1.948,0.052 2.188,0.271 0.24,0.219 10 false *a

Install a new piping clamp onto the suction hose sub-assembly.

Text in Illustration
*1 Suction Hose Sub-assembly
*2 Piping Clamp
*a Groove

NOTICE:

Securely engage the inside step of the piping clamp in the suction hose sub-assembly groove.



c.

Thoroughly coat 2 new O-rings and the contact surface of the suction hose sub-assembly with compressor oil (ND-OIL 11).


d.

Install the 2 O-rings onto the suction hose sub-assembly.

NOTICE:

Do not let foreign matter adhere to the O-ring or O-ring seal.



e.
E248687E03
0.271,1.771 0.271,2.479 false 2.271,1.75 2.271,2.458 false 0.854,1.635 1.396,0.938 false 1.438,0.781 1.729,1.021 0.292,0.24 10 false *a 0.198,2.49 0.49,2.729 0.292,0.24 10 false *b 2.198,2.479 2.49,2.719 0.292,0.24 10 false *b

Engage the suction pipe sub-assembly and suction hose sub-assembly by matching the alignment marks.

Text in Illustration
*1 Large Diameter Section of Piping Clamp
*2 Alignment Mark

NOTICE:

Insert them by holding the pipe, not the piping clamp.



f.
E248688E01
0.653,0.119 0.922,0.349 0.270,0.230 10 *a 1.459,0.815 0.873,0.229 false

Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction pipe sub-assembly.

Text in Illustration
*a Large Diameter Section of Piping Clamp

HINT:
·

When inserting, make sure that a click sound is heard.

·

Check that the suction pipe sub-assembly is securely inserted by pulling it.




Hide 17751 2.INSTALL NO. 1 AIR CLEANER INLET

a.

Temporarily install the No. 1 air cleaner inlet.


b.

Install the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 3.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT