87107A
1.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Disengage the 3 claws and remove the clamp.
Remove the heater radiator unit sub-assembly from the air conditioner radiator assembly.
88515
2.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.
88501
3.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
w/ Cover:
Remove the 2 screws and cover sub-assembly.
Remove the 6 screws.
Disengage the clamp and disconnect the connector from the lower heater case.
Disengage the 4 claws and remove the lower heater case.
Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor from the upper heater case.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
88625
4.REMOVE FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)
88539J
5.REMOVE DRAIN COOLER HOSE
Remove the drain cooler hose.
87050D
6.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
When reusing the No. 2 air conditioning radiator damper servo sub-assembly:
Put matchmarks on the gears of the No. 2 air conditioning radiator damper servo sub-assembly and air conditioning radiator assembly as shown in the illustration.
| *a | Matchmark |
Remove the 2 screws and No. 2 air conditioning radiator damper servo sub-assembly.
87050C
7.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Remove the 2 screws and No. 1 air conditioning radiator damper servo sub-assembly.