Home › Vehicle Interior › HEATING / AIR CONDITIONING › ECO SWITCH
RM2170E _58 Vehicle Interior _057042 HEATING / AIR CONDITIONING _0278141 ECO SWITCH G

HEATING / AIR CONDITIONING  ECO SWITCH  INSPECTION  


PROCEDURE

Hide 87290F 1.INSPECT ECO MODE SWITCH (ECO SWITCH ASSEMBLY)

a.
U159669E02
0.179,0.183 0.337,0.340 0.158,0.157 10 *a 0.454,2.417 0.767,2.574 0.314,0.157 10 ECU 0.864,2.501 0.993,2.501 0.993,2.501 1.563,2.851 false 0.418,1.85 0.732,2.007 0.314,0.157 10 ILL+ 0.828,1.934 0.957,1.934 0.957,1.934 1.72,2.858 false 2.76,2.417 2.872,2.574 0.112,0.157 10 E 2.717,2.501 2.588,2.501 2.588,2.501 2.018,2.851 false 2.76,1.919 3.073,2.076 0.314,0.157 10 ILL- 2.717,2.003 2.588,2.003 2.588,2.003 1.865,2.845 false 1.564,1.825 1.863,1.981 0.299,0.156 10 G62

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
G62-6 (E) - G62-9 (ECU) ECO mode switch (eco switch assembly) on Below 1 Ω
G62-6 (E) - G62-9 (ECU) ECO mode switch (eco switch assembly) off 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(ECO Mode Switch (Eco Switch Assembly))

If the result is not as specified, replace the ECO mode switch (eco switch assembly).



b.

Check that the switch illuminates.

i.

Apply auxiliary battery voltage to the ion generator switch assembly and check that the switch illuminates.

OK:
Tester Connection Specified Condition
Auxiliary battery positive (+) → Terminal 8 (ILL+)
Auxiliary battery negative (-) → Terminal 7 (ILL-)
Illuminates


If the result is not as specified, replace the ECO mode switch (eco switch assembly).