Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2011.12–2014.12
RM2170E _59 Vehicle Exterior _057046 DOOR / HATCH _0278159 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL LH (for LHD)

Hide 53876A 2.REMOVE FRONT FENDER LINER LH (for LHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>REMOVAL).


Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 62112 4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)

Hide 5.REMOVE FRONT WHEEL RH (for RHD)

Hide 53875A 6.REMOVE FRONT FENDER LINER RH (for RHD)

Hide 67913 7.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 62111C 8.REMOVE COWL SIDE TRIM BOARD RH (for RHD)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 53601 9.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B284569

Disengage the 3 claws and disconnect the hood lock control lever sub-assembly.


b.

Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.


Hide 53510 10.REMOVE HOOD LOCK ASSEMBLY

a.
B297001

Remove the 3 bolts.


b.
B301501

Disconnect the hood lock control cable and remove the hood lock assembly.


Hide 53630 11.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

a.

Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and hood cable grommet as shown in the illustration.

B301503E01
2.958,0.841 3.118,0.992 0.159,0.151 10 *3 2.418,0.916 2.93,0.916 false 2.782,1.148 3.056,1.148 false 3.078,1.066 3.237,1.217 0.159,0.151 10 *1 4.142,1.55 3.918,1.55 false 4.816,1.483 4.976,1.634 0.159,0.151 10 *2 3.766,1.483 3.925,1.634 0.159,0.151 10 *1 4.644,1.55 4.808,1.55 false 6.717,2.976 6.378,2.709 false 6.202,2.61 6.402,2.761 0.201,0.151 10 *1 6.417,3.043 6.215,3.043 false 4.816,1.483 4.976,1.634 0.159,0.151 10 *2 6.073,2.968 6.232,3.119 0.159,0.151 10 *2 5.971,4.908 5.618,4.908 false 5.439,4.843 5.639,4.995 0.201,0.151 10 *1 6.25,4.947 6.463,4.947 false 6.491,4.884 6.650,5.036 0.159,0.151 10 *2

Text in Illustration
*1 Hood Lock Control Cable *2 Clamp
*3 Hood Cable Grommet - -

HINT:

Tape the screwdriver tip before use.



b.

Pull the hood lock control cable assembly from the engine compartment and remove it.


Hide 53630 12.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

a.

Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and grommet as shown in the illustration.

B453806E01
0.448,1.115 0.781,1.115 true 1.302,1.115 1.469,1.115 false 1.552,3.771 1.083,3.521 true 0.927,3.823 1.26,3.823 false 6.188,0.781 6.604,0.781 false 6.646,1.25 6.646,1.135 false 6.615,3.938 6.781,3.938 true 5.969,3.958 6.302,3.958 false 0.281,1.031 0.594,1.229 0.313,0.198 10 false *1 1.5,1.021 1.813,1.219 0.313,0.198 10 false *2 0.917,3.448 1.229,3.646 0.313,0.198 10 false *1 0.75,3.74 1.063,3.938 0.313,0.198 10 false *2 6.635,0.688 6.948,0.885 0.313,0.198 10 false *3 6.563,1.271 6.875,1.469 0.313,0.198 10 false *1 6.823,3.854 7.135,4.052 0.313,0.198 10 false *1 5.792,3.875 6.104,4.073 0.313,0.198 10 false *2

Text in Illustration
*1 Hood Lock Control Cable *2 Clamp
*3 Hood Cable Grommet - -

HINT:

Tape the screwdriver tip before use.



b.

Pull the hood lock control cable assembly from the engine compartment and remove it.