The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly.
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| B241A | ·
Malfunction in rear height control sensor sub-assembly ·
Open or short in rear height control sensor sub-assembly circuit |
·
Rear height control sensor sub-assembly ·
Harness or connector ·
Headlight leveling ECU assembly |
If either of the following is performed, initialization of the headlight leveling ECU assembly is necessary (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION).
Replacement of the headlight leveling ECU assembly.
Replacement or removal/installation of the rear height control sensor sub-assembly or work that changes the vehicle height such as replacement of suspension components.
Clear the DTCs (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC B241A is not output
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / HL Auto Leveling / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Height Sens Pw Supply Val | Rear height control sensor power supply value / 0.00 to 5.00 V | Approx. 5 V | - |
| Rr Height Sens Signal Val | Rear height control sensor signal value / 0.00 to 5.00 V | Approx. 2.5 V (When the vehicle is level) | Value changes according to vehicle height |
Normal conditions listed above are displayed.
OK
NG
Remove the rear height control sensor sub-assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL).
Inspect the rear height control sensor sub-assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION).
OK
NG
Disconnect the A34 headlight leveling ECU assembly connector.
Disconnect the R1 rear height control sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A34-19 (SHRL) - R1-2 (SHRR) | Always | Below 1 Ω |
| A34-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
OK
NG