The main body ECU (multiplex network body ECU) controls the front fog lights via the FR FOG relay in the instrument panel junction block assembly.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
Check the operation of the taillights.
Taillights operate normally.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Active Test.
Check that the relay operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Fog Light Relay | Front fog light relay | ON/OFF | Light control switch is in tail position |
Front fog light relay operates. (Front fog lights come on.)
OK
NG
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Connect a positive (+) lead from the auxiliary battery to terminal 3E-1*1 or 3F-1*2.
Connect a negative (-) lead from the auxiliary battery to terminal MB-14 (TRLY) and MB-13 (FFGO).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3C-7 - Body ground | Always | 11 to 14 V |
*1: for LHD
*2: for RHD
| *A | for LHD |
| *B | for RHD |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
OK
NG
Disconnect the A12 fog light assembly LH connector.
Disconnect the A63*1 or A11*2 fog light assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A12-2 - 3C-7 | Always | Below 1 Ω |
| A63-2*1 - 3C-7 | Always | Below 1 Ω |
| A11-2*2 - 3C-7 | Always | Below 1 Ω |
| 3C-7 - Body ground | Always | 10 kΩ or higher |
*1: for LED Headlight
*2: for Halogen Headlight
OK
NG