The main body ECU (multiplex network body ECU) receives the following switch information:
Light control switch is in off, tail or head position
Dimmer switch is in high, low or high flash (pass) position
Front fog light switch is in on or off position
Rear fog light switch is in on or off position
for LHD
for RHD
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Dimmer SW | Dimmer switch high position signal/ON or OFF | ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position |
- |
| Passing Light SW | Dimmer switch high flash position (pass) signal/ON or OFF | ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position |
- |
| Rear Fog Light SW*1 | Rear fog light switch signal/ON or OFF | ON: Rear fog light switch on
OFF: Rear fog light switch off |
- |
| Front Fog Light SW | Front fog light switch signal/ON or OFF | ON: Front fog light switch on
OFF: Front fog light switch off |
- |
| Head Light SW (Head) | Light control switch head position signal/ON or OFF | ON: Light control switch in head position
OFF: Light control switch not in head position |
- |
| Head Light SW (Tail) | Light control switch tail position signal/ON or OFF | ON: Light control switch in tail or head position
OFF: Light control switch in neither tail nor head position |
- |
*1: w/ Rear Fog Light
Normal conditions listed above are displayed.
OK
NG
Inspect the items that did not change as a result of monitoring the Data List.
Remove the headlight dimmer switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT DIMMER SWITCH>REMOVAL).
for LHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 18 (T) - 12 (EL) | Light control switch off | 10 kΩ or higher |
| 20 (H) - 12 (EL) | Light control switch off | 10 kΩ or higher |
| 18 (T) - 12 (EL) | Light control switch in tail position | Below 1 Ω |
| 18 (T) - 12 (EL) | Light control switch in head position | Below 1 Ω |
| 20 (H) - 12 (EL) | Light control switch in head position | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 11 (HU) - 12 (EL) | Dimmer switch in low position | 10 kΩ or higher |
| 11 (HU) - 12 (EL) | Dimmer switch in high position | Below 1 Ω |
| 17 (HF) - 12 (EL) | Dimmer switch in high flash position | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (BFG) - 3 (LFG) | Font fog light switch off | 10 kΩ or higher |
| 4 (BFG) - 3 (LFG) | Font fog light switch on | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (B) - 3 (LFG) | Rear fog light switch off | 10 kΩ or higher |
| 2 (B) - 3 (LFG) | Rear fog light switch on | Below 1 Ω |
*1: w/ Rear Fog Light
Headlight dimmer switch assembly is normal.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
for RHD:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 13 (T) - 19 (EL) | Light control switch off | 10 kΩ or higher |
| 11 (H) - 19 (EL) | Light control switch off | 10 kΩ or higher |
| 13 (T) - 19 (EL) | Light control switch in tail position | Below 1 Ω |
| 13 (T) - 19 (EL) | Light control switch in head position | Below 1 Ω |
| 11 (H) - 19 (EL) | Light control switch in head position | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 20 (HU) - 19 (EL) | Dimmer switch in low position | 10 kΩ or higher |
| 20 (HU) - 19 (EL) | Dimmer switch in high position | Below 1 Ω |
| 14 (HF) - 19 (EL) | Dimmer switch in high flash position | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (BFG) - 8 (LFG) | Font fog light switch off | 10 kΩ or higher |
| 7 (BFG) - 8 (LFG) | Font fog light switch on | Below 1 Ω |
Headlight dimmer switch assembly is normal.
| *a | Component without harness connected
(Headlight Dimmer Switch Assembly) |
OK
NG
Disconnect the G59 main body ECU (multiplex network body ECU) connector.
for LHD
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G10-2 (B) - G59-1 (RFOG)*1 | Always | Below 1 Ω |
| G10-4 (BFG) - G59-27 (FFOG) | Always | Below 1 Ω |
| G10-11 (HU) - G59-5 (HU) | Always | Below 1 Ω |
| G10-17 (HF) - G59-8 (HF) | Always | Below 1 Ω |
| G10-18 (T) - G59-30 (TAIL) | Always | Below 1 Ω |
| G10-20 (H) - G59-29 (HEAD) | Always | Below 1 Ω |
| G10-2 (B) - Body ground*1 | Always | 10 kΩ or higher |
| G10-4 (BFG) - Body ground | Always | 10 kΩ or higher |
| G10-11 (HU) - Body ground | Always | 10 kΩ or higher |
| G10-17 (HF) - Body ground | Always | 10 kΩ or higher |
| G10-18 (T) - Body ground | Always | 10 kΩ or higher |
| G10-20 (H) - Body ground | Always | 10 kΩ or higher |
| G10-12 (EL) - Body ground | Always | Below 1 Ω |
| G10-3 (LFG) - Body ground | Always | Below 1 Ω |
*1: w/ Rear Fog Light
for RHD
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G9-7 (BFG) - G59-27 (FFOG) | Always | Below 1 Ω |
| G9-20 (HU) - G59-5 (HU) | Always | Below 1 Ω |
| G9-14 (HF) - G59-8 (HF) | Always | Below 1 Ω |
| G9-13 (T) - G59-30 (TAIL) | Always | Below 1 Ω |
| G9-11 (H) - G59-29 (HEAD) | Always | Below 1 Ω |
| G9-7 (BFG) - Body ground | Always | 10 kΩ or higher |
| G9-20 (HU) - Body ground | Always | 10 kΩ or higher |
| G9-14 (HF) - Body ground | Always | 10 kΩ or higher |
| G9-13 (T) - Body ground | Always | 10 kΩ or higher |
| G9-11 (H) - Body ground | Always | 10 kΩ or higher |
| G9-19 (EL) - Body ground | Always | Below 1 Ω |
| G9-8 (LFG) - Body ground | Always | Below 1 Ω |
OK
NG