Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2014.12–2017.06
RM2170E _59 Vehicle Exterior _057049 LIGHTING (EXT) _0278196 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Headlight Dimmer Switch Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) receives the following switch information:

·

Light control switch is in off, tail or head position

·

Dimmer switch is in high, low or high flash (pass) position

·

Front fog light switch is in on or off position


WIRING DIAGRAM

E241398E02
5.427,6.885 7.115,7.563 1.688,0.677 10 false Main Body ECU (Multiplex Network Body ECU) 6.021,0.583 6.135,0.729 0.115,0.146 10 false 5 6.021,0.771 6.198,0.917 0.177,0.146 10 false 8 5.958,5.615 6.135,5.76 0.177,0.146 10 false 27 6.188,0.865 6.396,1.01 0.208,0.146 10 false HF 6.188,0.656 6.417,0.802 0.229,0.146 10 false HU 6.188,5.708 6.729,5.885 0.542,0.177 10 false FFOG 0.469,8.198 0.781,8.365 0.313,0.167 10 false G9 0.469,8.365 2.781,8.615 2.313,0.25 10 false Headlight Dimmer Switch Assembly 1.271,6.531 2.01,6.885 0.74,0.354 10 false Fog Light Switch 2.219,6.604 2.458,6.75 0.24,0.146 10 false Off 2.156,6.969 2.531,7.125 0.375,0.156 10 false Front 4.958,0.771 5.198,0.917 0.24,0.146 10 false 14 0.354,7.771 0.448,7.917 0.094,0.146 10 false 8 5,5.615 5.146,5.76 0.146,0.146 10 false 7 0.25,5.708 0.448,5.854 0.198,0.146 10 false 19 4.958,0.583 5.198,0.729 0.24,0.146 10 false 20 2.667,6.229 2.979,6.375 0.313,0.146 10 false LFG 0.521,7.771 0.99,7.917 0.469,0.146 10 false LFG 3.125,6.229 3.438,6.375 0.313,0.146 10 false BFG 4.604,5.615 4.938,5.792 0.333,0.177 10 false BFG 1.302,1.479 1.833,1.865 0.531,0.385 10 false Dimmer Switch 2.177,2.208 2.51,2.406 0.333,0.198 10 false High 2.177,1.802 2.469,1.969 0.292,0.167 10 false Low 2.156,1.417 2.573,1.635 0.417,0.219 10 false Flash 4.146,1.104 4.365,1.25 0.219,0.146 10 false HF 4.677,0.781 4.896,0.927 0.219,0.146 10 false HF 3.271,1.104 3.51,1.25 0.24,0.146 10 false HL 3.708,1.104 3.948,1.25 0.24,0.146 10 false HU 4.677,0.583 4.917,0.729 0.24,0.146 10 false HU 1.135,4.083 1.615,4.594 0.479,0.51 10 false Light Control Switch 1.969,4.042 2.208,4.188 0.24,0.146 10 false Off 1.969,4.458 2.229,4.604 0.26,0.146 10 false Tail 1.917,4.885 2.302,5.031 0.385,0.146 10 false Head 3.219,3.698 3.427,3.854 0.208,0.156 10 false T 4.781,2.604 4.896,2.76 0.115,0.156 10 false T 3.708,3.677 3.844,3.833 0.135,0.156 10 false H 4.771,2.917 4.906,3.073 0.135,0.156 10 false H 0.51,5.708 0.708,5.865 0.198,0.156 10 false EL 2.677,3.688 2.875,3.844 0.198,0.156 10 false EL 2.75,1.115 3,1.271 0.25,0.156 10 false ED 4.979,2.594 5.208,2.75 0.229,0.156 10 false 13 5.958,2.896 6.135,3.052 0.177,0.156 10 false 29 4.979,2.906 5.167,3.063 0.188,0.156 10 false 11 5.958,2.604 6.135,2.76 0.177,0.156 10 false 30 6.208,3.01 6.615,3.167 0.406,0.156 10 false HEAD 6.208,2.698 6.531,2.854 0.323,0.156 10 false TAIL 5.427,6.729 5.74,6.875 0.313,0.146 10 false G59

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

Read the Data List according to the display on the intelligent tester.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Dimmer SW Dimmer switch high position signal/ON or OFF ON: Dimmer switch in high or high flash position
OFF: Dimmer switch in low position
-
Passing Light SW Dimmer switch high flash position (pass) signal/ON or OFF ON: Dimmer switch in high flash position
OFF: Dimmer switch not in high flash position
-
Front Fog Light SW Front fog light switch signal/ON or OFF ON: Front fog light switch on
OFF: Front fog light switch off
*
Head Light SW (Head) Light control switch head position signal/ON or OFF ON: Light control switch in head position
OFF: Light control switch not in head position
-
Head Light SW (Tail) Light control switch tail position signal/ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch in neither tail nor head position
-

*: w/ Front Fog Light


OK:

Normal conditions listed above are displayed.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
HINT:

Inspect the items that did not change as a result of monitoring the Data List.


a.

Remove the headlight dimmer switch assembly (See page Vehicle Exterior>LIGHTING (EXT)>HEADLIGHT DIMMER SWITCH>REMOVAL).


b.
E223779E63
0.063,0.049 0.242,0.229 0.179,0.180 10 *a 2.769,1.878 2.905,2.038 0.135,0.161 10 H 1.985,1.879 2.189,2.039 0.204,0.161 10 HF 1.544,0.234 2.172,0.395 0.628,0.161 10 BFG*A 1.049,1.868 1.236,2.028 0.187,0.161 10 EL 0.615,1.866 0.836,2.027 0.221,0.161 10 HU 1.128,1.416 1.139,1.859 false 2.545,1.39 2.814,1.833 false 2.183,1.412 2.309,1.855 false 1.999,1.404 2.102,1.848 false 2.297,1.887 2.401,2.048 0.104,0.161 10 T 0.949,1.407 0.726,1.85 false 0.765,0.251 1.303,0.412 0.538,0.161 10 LFG*A 1.477,1.063 1.766,0.432 false 1.295,1.063 1.005,0.432 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Light Control Switch
Tester Connection Condition Specified Condition
13 (T) - 19 (EL) Light control switch off 10 kΩ or higher
11 (H) - 19 (EL) Light control switch off 10 kΩ or higher
13 (T) - 19 (EL) Light control switch in tail position Below 1 Ω
13 (T) - 19 (EL) Light control switch in head position Below 1 Ω
11 (H) - 19 (EL) Light control switch in head position Below 1 Ω

Dimmer Switch
Tester Connection Condition Specified Condition
20 (HU) - 19 (EL) Dimmer switch in low position 10 kΩ or higher
20 (HU) - 19 (EL) Dimmer switch in high position Below 1 Ω
14 (HF) - 19 (EL) Dimmer switch in high flash position Below 1 Ω

Front Fog Light Switch*
Tester Connection Condition Specified Condition
7 (BFG) - 8 (LFG) Font fog light switch off 10 kΩ or higher
7 (BFG) - 8 (LFG) Font fog light switch on Below 1 Ω


*: w/ Front Fog Light


Text in Illustration
*A w/ Front Fog Light
*a Component without harness connected
(Headlight Dimmer Switch Assembly)



OK

3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU - HEADLIGHT DIMMER SWITCH ASSEMBLY)

NG

REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU - HEADLIGHT DIMMER SWITCH ASSEMBLY)
a.

Disconnect the G59 main body ECU (multiplex network body ECU) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G9-7 (BFG) - G59-27 (FFOG)* Always Below 1 Ω
G9-20 (HU) - G59-5 (HU) Always Below 1 Ω
G9-14 (HF) - G59-8 (HF) Always Below 1 Ω
G9-13 (T) - G59-30 (TAIL) Always Below 1 Ω
G9-11 (H) - G59-29 (HEAD) Always Below 1 Ω
G9-7 (BFG) - Body ground* Always 10 kΩ or higher
G9-20 (HU) - Body ground Always 10 kΩ or higher
G9-14 (HF) - Body ground Always 10 kΩ or higher
G9-13 (T) - Body ground Always 10 kΩ or higher
G9-11 (H) - Body ground Always 10 kΩ or higher
G9-19 (EL) - Body ground Always Below 1 Ω
G9-8 (LFG) - Body ground* Always Below 1 Ω


*: w/ Front Fog Light




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR