Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58165F
2.REMOVE FRONT FLOOR COVER RH
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
86160P
5.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
67832
6.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
7.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68210C
8.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
Apply protective tape to the door panel in the area around the front door glass outer weatherstrip assembly.
| *1 | Protective Tape |
Using a screwdriver with the tip wrapped with protective tape, disengage the 5 claws.
| *1 | Protective Tape |
Disengage the guide and remove the front door glass outer weatherstrip assembly.