Use the same procedure for both the RH and LH side.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58165F
2.REMOVE FRONT FLOOR COVER RH
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67674A
4.REMOVE REAR DOOR FRAME GARNISH
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER
67872
8.DISCONNECT REAR DOOR WEATHERSTRIP
68152C
9.REMOVE REAR DOOR GLASS RUN
67408E
10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
68230C
12.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip assembly.
| *1 | Protective Tape |
Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws.
| *1 | Protective Tape |
Disengage the guide and remove the rear door glass outer weatherstrip assembly.