Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › from 2015.11
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278212 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH side.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67674A 4.REMOVE REAR DOOR FRAME GARNISH

Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67842E 7.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 68152C 9.REMOVE REAR DOOR GLASS RUN

Hide 67408E 10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68104 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 68230C 12.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B298003E01
3.058,0.886 3.238,1.052 0.181,0.166 10 *1 3.045,0.972 2.435,0.972 false

Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip assembly.

Text in Illustration
*1 Protective Tape


b.
B298001E01
2.415,2.7 2.574,2.858 0.159,0.159 10 *1 2.412,2.788 2.114,2.788 false

Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws.

Text in Illustration
*1 Protective Tape


c.

Disengage the guide and remove the rear door glass outer weatherstrip assembly.