Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR OUTSIDE GARNISH
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278215 BACK DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  BACK DOOR OUTSIDE GARNISH  INSTALLATION  


PROCEDURE

Hide 76821A 1.INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH PROTECTOR

a.

Clean the luggage compartment door outside garnish sub-assembly.

i.

Remove any double-sided tape from the luggage compartment door outside garnish sub-assembly.


ii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new luggage compartment door outside garnish protector.

i.

Remove the release paper from the luggage compartment door outside garnish protector.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



ii.

Install a new luggage compartment door outside garnish protector as shown in the illustration.

B298028E02
0.553,2.169 0.703,2.346 0.151,0.177 10 A 5.995,2.217 6.146,2.393 0.151,0.177 10 B

Standard Measurement
Dimension Measurement
A 1.0 mm (0.0394 in.)
B 1.0 mm (0.0394 in.)



Hide 76801A 2.INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.

Install 5 new gaskets to the luggage compartment door outside garnish sub-assembly.


b.

Install the back door opener switch assembly (See page Vehicle Exterior>DOOR / HATCH>BACK DOOR OPENER SWITCH>INSTALLATION).


c.

Engage the clip.


d.

Install the luggage compartment door outside garnish sub-assembly with the 5 nuts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


e.

Connect the connector.


Hide 67761A 3.INSTALL BACK DOOR TRIM COVER

Hide 67750 4.INSTALL BACK DOOR TRIM BOARD ASSEMBLY