68961
1.INSTALL BACK DOOR STAY BOLT LH
68961
2.INSTALL BACK DOOR STAY BOLT RH
Use the same procedure as for the LH side.
68946
3.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET LH
68945
4.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET RH
Use the same procedure as for the LH side.
68960B
5.INSTALL BACK DOOR STAY ASSEMBLY LH
68950C
6.INSTALL BACK DOOR STAY ASSEMBLY RH
Use the same procedure as for the LH side.
85110R
7.INSTALL REAR WIPER MOTOR ASSEMBLY
85345R
8.INSTALL REAR WASHER NOZZLE
85345R
9.INSPECT REAR WASHER NOZZLE
85345R
10.ADJUST REAR WASHER NOZZLE
11.INSTALL REAR SPOILER ASSEMBLY
81270
12.INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
81270
13.INSTALL LICENSE PLATE LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
76801A
14.INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
86790D
15.INSTALL REAR TELEVISION CAMERA ASSEMBLY (w/ Rear Monitor)
69350
16.INSTALL BACK DOOR LOCK ASSEMBLY
Make sure to remove the string before installing a new back door lock assembly.
Apply MP grease to the sliding parts of the back door lock assembly.
Install the back door lock assembly with the 2 bolts.
Connect the connector.
67005B
17.INSTALL BACK DOOR PANEL CUSHION
Engage the 2claws to install the 2 back door panel cushions.
74811B
18.INSTALL DOOR PULL HANDLE
Engage the 4 claws to install the door pull handle.
With the back door fully open, install the door pull handle so that the arrow on the backside of door pull handle points up.
67761A
19.INSTALL BACK DOOR TRIM COVER
Engage the 5 clips to install the back door trim cover.
67750
20.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Install the back door trim board assembly with the 10 clips.