Use this procedure to troubleshoot the engine immobiliser system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
A simple method to determine whether the auxiliary battery is discharged is to operate the horn.
| Proceed to |
|---|
| NEXT |
NEXT
If the power switch cannot be turned on (IG), communication with the intelligent tester can be confirmed by connecting the intelligent tester to the vehicle and turning a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
(See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Use the intelligent tester to check if the LIN communication system is functioning normally (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| LIN DTC is not output | A |
| LIN DTC is output | B |
A
B
Check for DTCs and make a note of any codes that are output (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Based on the DTCs output above, proceed to each diagnostic procedure.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| Hybrid control system DTC is output | B |
| Steering lock system DTC is output | C |
| Engine immobiliser system DTC is output | D |
A
B
(See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
C
D
Refer to Problem Symptoms Table (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>PROBLEM SYMPTOMS TABLE).
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DATA LIST / ACTIVE TEST).
Terminals of ECU (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>TERMINALS OF ECU).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| Engine immobiliser system DTC is output | B |
A
B