Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › EXHAUST PIPE GAS CONTROL ACTUATOR › from 2017.06
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0320241 EXHAUST PIPE GAS CONTROL ACTUATOR A

1NZ-FXE COOLING  EXHAUST PIPE GAS CONTROL ACTUATOR  INSTALLATION  


PROCEDURE

Hide 17046 1.INSTALL EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY

a.

Install the exhaust by-pass pipe to the exhaust pipe gas control actuator sub-assembly.

NOTICE:
·

When reusing the exhaust by-pass pipe, inspect the O-ring.


·

If the O-ring has scratches or cuts, replace the exhaust by-pass pipe.




b.
A408522N01
1.854,1.927 2.052,2.167 0.198,0.24 10 false A 2.417,1.688 2.615,1.927 0.198,0.24 10 false A 2.083,0.708 2.281,0.948 0.198,0.24 10 true A 1.813,0.615 2.031,0.823 0.219,0.208 10 true B 0.625,0.594 0.844,0.802 0.219,0.208 10 true B

Install the No. 1 exhaust pipe heat insulator and exhaust pipe gas control actuator sub-assembly with the exhaust by-pass pipe installed with the 5 bolts.

Torque:
Bolt (A) : 5.0 N*m (51 kgf*cm, 44 in.*lbf)
Bolt (B) : 8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Do not apply any excessive force to the exhaust by-pass pipe when installing the exhaust pipe gas control actuator sub-assembly.



c.

When replacing the exhaust pipe gas control actuator sub-assembly with a new one:

i.
A279079C02
2.385,2.031 2.146,2.031 2.146,2.031 1.458,2.417 true 2.417,1.938 2.583,2.104 0.167,0.167 10 false *a
*a Spacer


Remove the spacer from the new exhaust pipe gas control actuator sub-assembly.

HINT:

The exhaust pipe gas control actuator sub-assembly is supplied with a spacer that must be removed after installation.




Hide 17410 2.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 4.INSPECT FOR COOLANT LEAK (for Engine)