Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › EXHAUST PIPE GAS CONTROL ACTUATOR › from 2017.06
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0320241 EXHAUST PIPE GAS CONTROL ACTUATOR A

1NZ-FXE COOLING  EXHAUST PIPE GAS CONTROL ACTUATOR  REMOVAL  


PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 17046 3.REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR SUB-ASSEMBLY

a.
A279077

Remove the 5 bolts, No. 1 exhaust pipe heat insulator and exhaust pipe gas control actuator sub-assembly with the exhaust by-pass pipe installed.

NOTICE:
·

When removing the exhaust pipe gas control actuator sub-assembly, use caution because engine coolant may spill out from the exhaust heat recirculation system.

·

Do not apply any excessive force to the exhaust by-pass pipe when removing the exhaust pipe gas control actuator sub-assembly.




b.

Remove the exhaust by-pass pipe from the exhaust pipe gas control actuator sub-assembly.