WHEN USING GTS
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One to drive the vehicle, and another to operate the GTS.
INITIALIZATION
Perform Registration (VIN registration) when replacing the ECM.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM(w/ Canister Pump Module)>REGISTRATION
Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
PRECAUTIONS FOR INSPECTING HYBRID CONTROL SYSTEM
Refer to Hybrid Control System.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
NOTICE FOR HYBRID CONTROL SYSTEM ACTIVATION
Refer to Hybrid Control System.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
COOLING FAN SYSTEM
When the power switch is turned off and the engine temperature is high, the engine water pump assembly and cooling fans may operate for a maximum of 2 minutes depending on the auxiliary battery voltage.
After turning the power switch off, keep hands and objects away from the fans when they are operating.
If all of the following are met for a certain period of time during a few minutes immediately before the power switch is turned off, the cooling fans will continue to operate for a maximum of 2 minutes after the engine is stopped. This is performed to ensure restartability.
The GTS indicates a very high coolant temperature.
The GTS indicates a high outside air temperature.