When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following procedure, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.
1.CHECK AUXILIARY BATTERY VOLTAGE
Carry out this check with the ignition stopped and the power switch off.
| Result | Proceed to |
|---|---|
| 11 V or higher | GO TO STEP 2 |
| Below 11 V | CHARGE OR REPLACE AUXILIARY BATTERY |
2.CHECK WHETHER ENGINE CRANKS
| Result | Proceed to |
|---|---|
| OK | GO TO STEP 3 |
| NG | PROCEED TO PROBLEM SYMPTOMS TABLE
( )
|
3.CHECK WHETHER ENGINE STARTS
| Result | Proceed to |
|---|---|
| OK | GO TO STEP 4 |
| NG | GO TO STEP 6 |
4.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.
| Result | Proceed to |
|---|---|
| OK | GO TO STEP 5 |
| NG | REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
5.CHECK IDLE SPEED
Check the engine idle speed.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE MECHANICAL)>ENGINE>ON-VEHICLE INSPECTION
| Result | Proceed to |
|---|---|
| OK | GO TO STEP 6 |
| NG | TROUBLESHOOT IDLE SPEED AND PROCEED TO NEXT STEP |
6.CHECK FUEL PRESSURE
Check the fuel pressure.
Click hereEngine / Hybrid System>1NZ-FXE FUEL>FUEL SYSTEM>ON-VEHICLE INSPECTION
| Result | Proceed to |
|---|---|
| OK | GO TO STEP 7 |
| NG | TROUBLESHOOT FUEL PRESSURE AND PROCEED TO NEXT STEP |
7.CHECK FOR SPARK
Perform a spark test.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>IGNITION SYSTEM>ON-VEHICLE INSPECTION
| Result | Proceed to |
|---|---|
| OK | PROCEED TO PROBLEM SYMPTOMS TABLE
( )
|
| NG | TROUBLESHOOT SPARK AND PROCEED TO NEXT STEP |