1.REMOVE FRONT WHEEL LH (for LHD)
53876A
2.REMOVE FRONT FENDER LINER LH (for LHD)
Use the same procedure for the RH side and LH side (See page Vehicle Exterior>WIPER / WASHER>WASHER MOTOR(for Front Side)>REMOVAL).
67914
3.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
62112
4.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
5.REMOVE FRONT WHEEL RH (for RHD)
53875A
6.REMOVE FRONT FENDER LINER RH (for RHD)
67913
7.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
62111C
8.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
53601
9.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disengage the 3 claws and disconnect the hood lock control lever sub-assembly.
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
53510
10.REMOVE HOOD LOCK ASSEMBLY
Remove the 3 bolts.
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
53630
11.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and hood cable grommet as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | - | - |
| *a | Clamp | *b | Hood Cable Grommet |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment and remove it.
53630
12.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and hood cable grommet as shown in the illustration.
| *1 | Hood Lock Control Cable Assembly | - | - |
| *a | Clamp | *b | Hood Cable Grommet |
Tape the screwdriver tip before use.
Pull the hood lock control cable assembly from the engine compartment and remove it.