Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PRESSURE REGULATOR(w/o Canister Pump Module) › from 2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0320553 FUEL PRESSURE REGULATOR(w/o Canister Pump Module) A

1NZ-FXE FUEL  FUEL PRESSURE REGULATOR(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 23280J 1.INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

a.

Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.


b.

Install the fuel pressure regulator assembly to the fuel suction plate sub-assembly.

NOTICE:

Make sure that the O-rings are not cut or pinched during installation.



c.

Install the No. 2 fuel suction support to the fuel suction plate sub-assembly.


Hide 77020A 2.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY