83320
1.REMOVE FUEL SENDER GAUGE ASSEMBLY
23220A
2.REMOVE FUEL PUMP WITH FILTER ASSEMBLY
Disconnect the fuel pump harness connector.
Disconnect the suction filter hose.
| *a | No. 1 Fuel Sub-tank |
| *b | Fuel Tube |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump with filter assembly from the No. 1 fuel sub-tank.
Do not do anything which may separate the fuel tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the fuel tube.
Click hereEngine / Hybrid System>1NZ-FXE FUEL>FUEL SYSTEM>PRECAUTION
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
| *a | Fuel Filter |
| *b | Suction Filter |
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump with filter assembly from the fuel filter.
Do not damage the fuel filter.
Do not remove the suction filter.
Do not use either the fuel pump with filter assembly or the suction filter if the suction filter is removed from the fuel pump with filter assembly.
Disconnect the fuel pump harness connector.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
Remove the O-ring and fuel pump spacer from the fuel pump with filter assembly.
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm (0.0394 in.) diameter) that is formed as shown in the illustration.