23221
1.INSTALL FUEL PUMP
Perform "Inspection After Repair" after replacing the fuel pump.
Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.
Engage the 3 claws to install the fuel pump to the fuel suction plate sub-assembly.
Engage the 4 claws to install the fuel suction plate sub-assembly to the fuel sub-tank sub-assembly.
Make sure that the O-ring is not cut or pinched during the installation.
Engage the claws securely.
| *a | Protrusion |
| *b | Installation Hole |
|
Slide |
Align the protrusion of the fuel sub-tank sub-assembly with the installation hole of the fuel suction plate sub-assembly and then slide the fuel suction plate sub-assembly to install the fuel sub-tank sub-assembly.
for Type A:
Engage the 3 clamps and install the fuel pump harness to the fuel suction plate sub-assembly.
Connect the 2 fuel pump harness connectors.
for Type B:
Connect the 2 fuel pump harness connectors to install the fuel pump harness to the fuel suction plate sub-assembly.
Engage the 2 clamps.
83320
2.INSTALL FUEL SENDER GAUGE ASSEMBLY