77217C
1.INSTALL NO. 2 FUEL TANK FILLER PIPE SUPPORT
Engage the claw to install the No. 2 fuel tank filler pipe support in the position shown in the illustration.
77216A
2.INSTALL NO. 1 FUEL TANK FILLER PIPE SUPPORT
| *a | Clamp Position |
Install the No. 1 fuel tank filler pipe support in the position shown in the illustration.
77262
3.INSTALL NO. 2 FUEL EMISSION TUBE
Engage the 2 clamps to install the No. 2 fuel emission tube to the fuel tank assembly.
77209F
4.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
Engage the 2 clamps to install the fuel tank main tube sub-assembly to the fuel tank assembly.
77281G
5.INSTALL FUEL HOSE CLAMP
Install the fuel hose clamp to the fuel tank assembly.
77701W
6.INSTALL NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY
Engage the clamp to install the No. 1 canister outlet hose sub-assembly to the fuel tank assembly.
77100
7.INSTALL FUEL TANK ASSEMBLY
Clean the bolt holes.
Using an engine lifter, set the fuel tank assembly in the installation position.
Be careful not to drop the fuel tank assembly.
Install the fuel tank assembly with 4 new bolts.
Engage the 2 clamps install the 2 fuel hoses to the position shown in the illustration.
| *1 | Fuel Tank Filler Pipe Flange Plate |
| *a | Air Tube |
Engage the claw and install the fuel tank filler pipe flange plate as shown in the illustration.
Install the bolt.
Engage the 2 clamps to install the air tube as shown in the illustration.
77209F
8.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Align the fuel tube connector with the fuel pipe, connect the fuel tube connector and push the retainer in until the retainer makes a "click" sound to lock the claws of the retainer.
| *1 | Fuel Tank Main Tube Sub-assembly | *2 | Fuel Tank Pipe Setting Holder |
| *a | Retainer | *b | Nylon Tube |
| *c | O-ring | *d | Fuel Tube Connector |
| *e | Fuel Pipe | - | - |
Check that there is no damage or foreign matter around the connecting parts of the fuel tube connector and fuel pipe before starting this step.
After connecting the fuel tube connector, check that the fuel tube connector is securely connected by pulling on the fuel tube connector.
Engage the 3 clamps to install the fuel tank pipe setting holder.
77266A
9.INSTALL NO. 1 FUEL TUBE PROTECTOR
Install the No. 1 fuel tube protector to the fuel tube connector.
77262
10.CONNECT NO. 2 FUEL EMISSION TUBE
| *1 | No. 2 Fuel Emission Tube |
| *a | Up |
| *b | 120° |
| *c | Fuel Pipe |
| *d | Paint Mark |
Connect the No. 2 fuel emission tube and slide the clip to secure it.
Check that there is no damage or foreign matter around the connecting parts of the No. 2 fuel emission tube and fuel pipe before performing this work.
Make sure the clip and No. 2 fuel emission tube are positioned within the area shown in the illustration.
77606
11.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
Install the No. 1 fuel tank protector sub-assembly with the bolt and clip.
58156
12.INSTALL FRONT NO. 4 FLOOR HEAT INSULATOR
|
Front |
Install the front No. 4 floor heat insulator with the 2 nuts.
77310A
13.INSTALL FUEL TANK CAP ASSEMBLY
77020A
14.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
15.ADD FUEL