Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278099 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

Deceleration sensors used for the airbag system are installed to various parts on the vehicle and calculate the deceleration rate of each part during a collision.


b.

Depending on the situation, the airbag sensor assembly sends a deployment signal to each airbag and pretensioner based on the information from each sensor.



DEPLOYMENT CONDITION (w/o Occupant Classification System)


a.

FRONTAL COLLISION

C245662E15
0.354,1.656 1.917,2.167 1.563,0.51 10 false Airbag Sensor Assembly 0.438,2.969 1.865,3.229 1.427,0.26 10 false Front Airbag Sensors 2.635,2.333 2.99,2.719 0.354,0.385 10 false AND 4.177,0.563 6.823,0.917 2.646,0.354 10 false Horn Button Assembly (Driver Side Squib) 4.021,1.208 6.865,1.875 2.844,0.667 10 false Instrument Panel Passenger Airbag Assembly (Front Passenger Side Squib) 3.979,2.094 6.885,2.635 2.906,0.542 10 false Lower No. 1 Instrument Panel Airbag Assembly (Driver Side Knee Airbag Squib) 4.24,2.979 6.635,3.448 2.396,0.469 10 false Curtain Shield Airbag Assembly LH/RH (Curtain Shield Squib LH/RH) 4.271,3.875 6.708,4.469 2.438,0.594 10 false Front Seat Outer Belt Assembly LH/RH (Front Pretensioner Squib LH/RH)

i.

Frontal collision signals are produced based on the information from the airbag sensor assembly and front airbag sensors.

HINT:

In the case of a frontal collision, the SRS ignition signal may be output after receiving an ON signal from the deceleration sensor built into the airbag sensor assembly even without a signal from the front airbag sensors.



ii.

Frontal collision signals are used to deploy the SRS parts in the diagram.



b.

SIDE COLLISION (Pattern 1)

C241767E10
5.021,0.438 6.802,1.146 1.781,0.708 10 false Front Seat Airbag Assembly (Side Squib) 4.896,1.667 6.906,2.25 2.01,0.583 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.406,0.594 2.281,0.969 1.875,0.375 10 false Side Airbag Sensor Assembly 0.563,1.917 2.146,2.396 1.583,0.479 10 false Airbag Sensor Assembly 3.531,1.292 3.948,1.792 0.417,0.5 10 false AND

i.

Side collision (Pattern 1) signals are produced based on the information from the airbag sensor assembly and side airbag sensor assembly.


ii.

Side collision (Pattern 1) signals are used to deploy the SRS parts in the diagram.



c.

SIDE COLLISION (Pattern 2)

C240621E09
4.875,1.073 6.875,1.427 2,0.354 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.188,0.479 2.438,0.677 2.25,0.198 10 false Side No. 2 Airbag Sensor Assembly 0.49,2.021 2.042,2.229 1.552,0.208 10 false Airbag Sensor Assembly 3.49,1.24 3.802,1.427 0.313,0.188 10 false AND

i.

Side collision (Pattern 2) signals are produced based on the information from the airbag sensor assembly and side No. 2 airbag sensor assembly.


ii.

Side collision (Pattern 2) signals are used to deploy the SRS part in the diagram.




DEPLOYMENT CONDITION (w/ Occupant Classification System)


a.

FRONTAL COLLISION

C247070E04
0.458,2.031 1.396,2.573 0.938,0.542 10 false Airbag Sensor Assembly 0.219,3.531 1.656,3.844 1.438,0.313 10 false Front Airbag Sensors 2.021,2.885 2.427,3.375 0.406,0.49 10 false AND 3.656,0.448 6.333,0.802 2.677,0.354 10 false Horn Button Assembly (Driver Side Squib) 3.021,1.302 6.958,1.75 3.938,0.448 10 false Instrument Panel Passenger Airbag Assembly (Front Passenger Side Squib/Passenger Side Airbag Variable Vent Hole Squib) 3.5,2.177 6.417,2.594 2.917,0.417 10 false Lower No. 1 Instrument Panel Airbag Assembly (Driver Side Knee Airbag Squib) 3,3.073 6.906,3.594 3.906,0.521 10 false Front Seat Airbag Sub-assembly LH/RH (Driver Side/Passenger Side Front Seat Cushion Squib) 3.781,3.969 6.188,4.427 2.406,0.458 10 false Curtain Shield Airbag Assembly LH/RH (Curtain Shield Squib LH/RH) 3.75,4.854 6.177,5.552 2.427,0.698 10 false Front Seat Outer Belt Assembly LH/RH (Front Pretensioner Squib LH/RH)

i.

Frontal collision signals are produced based on the information from the airbag sensor assembly and front airbag sensors.

HINT:

In the case of a frontal collision, the SRS ignition signal may be output after receiving an ON signal from the deceleration sensor built into the airbag sensor assembly even without a signal from the front airbag sensors.



ii.

Frontal collision signals are used to deploy the SRS parts in the diagram.

HINT:

The occupant classification system restricts the deployment of the instrument panel passenger airbag assembly, front seat airbag sub-assembly RH and front seat outer belt assembly RH (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>FAIL-SAFE CHART).




b.

SIDE COLLISION (Pattern 1)

C247071E10
0.344,0.323 1.573,0.781 1.229,0.458 10 false Side Airbag Sensor Assembly 0.198,1.292 1.813,1.635 1.615,0.344 10 false Door Side Airbag Sensor 0.198,2.115 1.833,2.406 1.635,0.292 10 false Airbag Sensor Assembly 2.49,0.906 2.917,1.438 0.427,0.531 10 false OR 3.552,1.344 4.115,1.927 0.563,0.583 10 false AND 5.01,0.24 6.792,0.729 1.781,0.49 10 false Front Seat Airbag Assembly (Side Squib) 4.875,1.104 6.875,1.604 2,0.5 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 4.865,1.979 6.885,2.604 2.021,0.625 10 false Front Seat Outer Belt Assembly (Front Pretensioner Squib)

i.

Side collision (Pattern 1) signals are produced based on the information from the airbag sensor assembly, side airbag sensor assembly and door side airbag sensor.


ii.

Side collision (Pattern 1) signals are used to deploy the SRS parts in the diagram.



c.

SIDE COLLISION (Pattern 2)

C240621E11
4.865,1.073 6.844,1.771 1.979,0.698 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.177,0.552 2.396,0.917 2.219,0.365 10 false Side No. 2 Airbag Sensor Assembly 0.521,2.094 2.094,2.552 1.573,0.458 10 false Airbag Sensor Assembly 3.5,1.302 3.99,1.792 0.49,0.49 10 false AND

i.

Side collision (Pattern 2) signals are produced based on the information from the airbag sensor assembly and side No. 2 airbag sensor assembly.


ii.

Side collision (Pattern 2) signals are used to deploy the SRS part in the diagram.



d.

ROLLOVER

B483306E01
0.458,1.177 2.146,1.656 1.688,0.479 10 false Airbag Sensor Assembly 4.219,1.667 6.625,2.125 2.406,0.458 10 false Curtain Shield Airbag Assembly LH/RH (Curtain Shield Squib LH/RH) 4.208,0.271 6.625,0.698 2.417,0.427 10 false Front Seat Outer Belt Assembly LH/RH (Front Pretensioner Squib LH/RH)

i.

A circuit to detect vehicle rollover is built into the airbag sensor assembly.


ii.

When the conditions for vehicle rollover are met, the airbag sensor assembly deploys the SRS parts in the diagram.