Home › Steering › STEERING COLUMN › STEERING WHEEL › from 2017.06
RM2170E _55 Steering _057027 STEERING COLUMN _0278048 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the steering sensor from the spiral cable.



PROCEDURE

Hide 45184 1.INSTALL LOWER STEERING WHEEL BOSS COVER

a.
C206252

Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.


Hide 84633 2.INSTALL CRUISE CONTROL SWITCH WIRE

a.

Install the cruise control switch wire.


Hide 4.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 5.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84307 6.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 7.INSTALL STEERING WHEEL ASSEMBLY

a.
C378301C01
0.385,0.594 1.677,0.594 true 0.677,0.594 0.677,0.719 0.677,0.719 1.677,0.719 true 0.229,0.51 0.542,0.667 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly.


Hide 8.CHECK STEERING WHEEL CENTER POINT

Hide 45130 9.INSTALL HORN BUTTON ASSEMBLY