The front lower No. 1 suspension arm sub-assembly LH can be removed directly from the vehicle.
1.REMOVE FRONT WHEEL
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (Integrated Cover Type)
48069
3.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the clip and nut.
Install SST to the threaded section of the lower ball joint.
Make sure that the upper ends of the threaded section of the lower ball joint and SST are aligned.
Using SST, separate the front lower No. 1 suspension arm sub-assembly LH from the steering knuckle.
| *a | Grease Application Area | *b | Place wrench here |
| *c | Center Nut | *d | String |
Apply grease to the threads and end of the SST bolt.
Be sure to tighten the string firmly to secure SST to the steering knuckle LH to prevent SST from falling off.
Install SST with the center nut so that (A) and (B) shown in the illustration are parallel. Otherwise, the ball joint dust cover may be damaged.
Be sure to place the wrench on the part shown in the illustration.
Do not damage the front disc brake dust cover.
Do not damage the ball joint dust cover.
Do not damage the steering knuckle LH.
48069
4.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the 2 bolts and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.
48068
5.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH