Setting the seat cushion of the front seat assembly using the vertical adjusting handle makes it easier to perform the following procedure.
71074S
1.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Disconnect the rubber band of the separate type front seatback cover.
71862
2.REMOVE FRONT SEAT INNER CUSHION SHIELD (for LHD Driver Side)
Disengage the 2 claws and 4 guides to remove the front seat inner cushion shield.
71861
3.REMOVE FRONT SEAT INNER CUSHION SHIELD (for RHD Driver Side)
Disengage the 2 claws and 5 guides to remove the front seat inner cushion shield.
71861
4.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
Disengage the 2 claws and 5 guides to remove the front seat inner cushion shield.
73240
5.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73230
6.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
7.REMOVE FRONT SEAT BELT ANCHOR PLATE
71849
8.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 seat adjuster cover caps.
72526A
9.REMOVE RECLINING ADJUSTER RELEASE HANDLE
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
| *1 | Protective Tape |
72495
10.REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)
Remove the screw and vertical adjusting handle.
71812D
11.REMOVE FRONT SEAT CUSHION SHIELD
Remove the screw.
Disengage the 2 claws, 4 guides and clip to remove the front seat cushion shield.
71874C
12.REMOVE FRONT SEAT LOWER CUSHION SHIELD (for Driver Side)
Disengage the 2 claws to remove the front seat lower cushion shield.
73920A
13.SEPARATE FRONT SEAT AIRBAG ASSEMBLY
Disengage the fastener and separate the front seat airbag assembly wire harness.
for LH Side:
Disengage the claw and 6 clamps to separate the front seat airbag assembly wire harness.
for RH Side:
Disengage the claw and 3 clamps to separate the front seat airbag assembly wire harness.
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
w/ Occupant Detection Sensor:
Disengage the clamp to remove the connector as shown in the illustration.
Disengage each hook and remove the separate type front seat cushion cover with pad.
73906
15.REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY (w/ Occupant Classification System)
71072S
16.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 hog rings.
Remove the 18 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.
17.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the 5 hog rings.
Remove the 3 hog rings.
Remove the 2 hog rings.
Turn back the separate type front seatback cover.
Remove the 2 nuts and the 3 brackets.
Disengage the 4 claws and remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad.
73920A
18.REMOVE FRONT SEAT AIRBAG ASSEMBLY
71074S
19.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 6 hog rings and separate type front seatback cover from the separate type front seatback pad.
71874
20.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)
Remove the screw.
Disengage the hook as shown in the illustration.
Disengage the clip and remove the front seat lower cushion shield LH.
71873
21.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)
Remove the screw.
Disengage the hook as shown in the illustration.
Disengage the clip and remove the front seat lower cushion shield RH.
71538B
22.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH (for Driver Side)
Disengage the 5 claws to remove the front seat cushion edge protector LH.
71537H
23.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH (for Driver Side)
Disengage the 5 claws to remove the front seat cushion edge protector RH.
71538A
24.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH (for Front Passenger Side)
Disengage the 5 claws to remove the front seat cushion edge protector LH.
71537G
25.REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH (for Front Passenger Side)
Disengage the 5 claws to remove the front seat cushion edge protector RH.
89952
26.REMOVE OCCUPANT DETECTION ECU (w/ Occupant Classification System)
82191
27.REMOVE FRONT SEAT WIRE RH (w/ Occupant Classification System)
Disconnect each connector and disengage each clamp to remove the front seat wire RH.
71640S
28.REMOVE SEPARATE TYPE FRONT SEATBACK SPRING ASSEMBLY
Remove the 4 bolts.
Disengage the 4 guides to remove the separate type front seatback spring assembly from the separate type front seat cushion spring assembly.
72265D
29.REMOVE SEAT TRACK UPPER RAIL COVER (for Front Side)
Operate the seat track adjusting handle and move the front seat adjuster assembly to the foremost position.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the seat track upper rail cover as shown in the illustration.
Use the same procedure for both sides.
72129D
30.REMOVE LOWER NO. 4 SEAT TRACK RAIL PROTECTOR
|
Removal in this Direction |
Disengage the 2 guides and 2 claws to remove the lower No. 4 seat track rail protector from the separate type front seat cushion spring assembly.
72265D
31.REMOVE SEAT TRACK UPPER RAIL COVER (for Rear Side)
Operate the seat track adjusting handle and move the front seat adjuster assembly to the rearmost position.
for LH Side:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the seat track upper rail cover as shown in the illustration.
for RH Side:
Use the same procedure as for the front side.
72129A
32.REMOVE LOWER NO. 2 SEAT TRACK RAIL PROTECTOR
|
Remove in this Direction |
Disengage the guide and 2 claws to remove the lower No. 2 seat track rail protector from the separate type front seat cushion spring assembly.
72211
33.REMOVE SEAT TRACK ADJUSTING HANDLE
Disengage the 2 springs to remove the seat track adjusting handle from the separate type front seat cushion spring assembly.