Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY(w/ Occupant Classification System) › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0321628 SRS SEAT CUSHION AIRBAG ASSEMBLY(w/ Occupant Classification System) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SRS SEAT CUSHION AIRBAG ASSEMBLY(w/ Occupant Classification System)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

If the front seat airbag sub-assembly was deployed, replace the front seat airbag sub-assembly, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage. (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>DISASSEMBLY)



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72526A 3.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 72495 4.REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)

Hide 71812D 5.REMOVE FRONT SEAT CUSHION SHIELD

Hide 71874C 6.REMOVE FRONT SEAT LOWER CUSHION SHIELD (for Driver Seat)

Hide 71862 7.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)

Hide 71862 8.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)

Hide 9.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Hide 73906 10.REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY

a.

for Driver Side:

i.
B300274

Disengage the claw and 4 clamps to separate the airbag wire harness.



b.

for Front Passenger Side:

i.
B300231

Disengage the claw and clamp.


ii.

Disconnect the airbag wire harness from the seat clamp.



c.
B300232

Disengage the 2 clamps.


d.

Remove the 3 nuts and the front seat airbag sub-assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.