89952
1.INSTALL OCCUPANT DETECTION ECU
Engage the claw to install the occupant detection ECU.
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
Connect the 2 connectors.
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.
2.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure for the RH side and LH side.
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (w/ Removable Headrest)>INSTALLATION)
3. PERFORM DIAGNOSTIC SYSTEM CHECK
4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK