Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278099 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1630/23  Rear Airbag Sensor RH Circuit Malfunction  


DESCRIPTION

The side collision sensor RH circuit (to determine deployment of the front seat airbag assembly RH, curtain shield airbag assembly RH and front seat outer belt assembly RH) is composed of the airbag sensor assembly, side airbag sensor assembly RH, side No. 2 airbag sensor assembly RH and door side airbag sensor RH*.

The side No. 2 airbag sensor assembly RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.

DTC B1630/23 is stored when a malfunction is detected in the side No. 2 airbag sensor assembly RH.

DTC No. DTC Detection Condition Trouble Area

*: w/ Occupant Classification System

B1630/23
·

Side No. 2 airbag sensor assembly RH malfunction

·

Airbag sensor assembly malfunction


·

Side No. 2 airbag sensor assembly RH

·

Airbag sensor assembly



WIRING DIAGRAM

Refer to DTCs B1622/81, B1623/81, B1632/81, B1633/81, B1642/81, B1643/81, B1692/81 and B1693/81 (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>B1622/81).

CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


PROCEDURE

1.CHECK SIDE NO. 2 AIRBAG SENSOR ASSEMBLY RH
a.
C238223C01
0.969,1.031 1.396,1.385 0.427,0.354 10 false *1 1.281,1.021 1.51,1.333 0.229,0.313 10 false D 1.438,1.021 1.646,1.292 0.208,0.271 10 false C 1.885,1.021 2.115,1.302 0.229,0.281 10 false B 2.042,1.021 2.281,1.25 0.24,0.229 10 false A 2.281,1.031 2.51,1.25 0.229,0.219 10 false *2
*1 Side No. 2 Airbag Sensor Assembly LH
*2 Side Airbag Sensor Assembly RH


Turn the power switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Interchange the side No. 2 airbag sensor assembly RH with LH and connect the connectors.


d.

Connect the cable to the negative (-) auxiliary battery terminal.



f.

Turn the power switch off.


g.

Turn the power switch on (IG), and wait for at least 60 seconds.


h.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC B1630/23 is output. A
DTC B1635/24 is output. B
DTCs B1630/23 and B1635/24 are not output. C


HINT:

Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.



i.

Turn the power switch off.


j.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



k.

Return the side No. 2 airbag sensor assembly RH and LH to their original positions and connect the connectors.



A

B

REPLACE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY RH

C