Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION SYSTEM › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0321828 OCCUPANT CLASSIFICATION SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION SYSTEM  B1796  Sleep Operation Failure of Occupant Classification ECU  


DESCRIPTION

In sleep mode, the occupant detection ECU reads the condition of each sensor while the power switch is off.

In this mode, if the occupant detection ECU detects an internal malfunction, DTC B1796 is stored.

DTC No. DTC Detection Condition Trouble Area
B1796

Occupant detection ECU malfunction


Occupant detection ECU



HINT:

When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1796 is output, perform troubleshooting for the DTC.


CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


PROCEDURE

1.REPLACE OCCUPANT DETECTION ECU
a.

Turn the power switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.



d.

Connect the cable to the negative (-) auxiliary battery terminal.



NEXT

2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
2.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
a.

Using the GTS, perform Zero Point Calibration and Sensitivity Check (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>INITIALIZATION).



NEXT

END